产品概述
The MC9S08SH4CTG is a 8-bit General-purpose MICrocontroller based on enhanced HCS08 CPU (20MHz bus) with CISC architecture operates at a maximum frequency of 40MHz. The device incorporates 4kB internal flash, 0.256kB internal RAM, an analog comparator, 8-channel 10-bit A/D converter and 13 general-purpose I/O pins. This device also features peripherals like one inter-integrated circuit (IIC) bus module to operate at up to 100kbps and one serial peripheral interface modules (SPI).
HC08 Instruction set with added BGND instruction
Support for up to 32 Interrupt/reset sources
Two very low power stop modes
Reduced power wait mode
Very low power real time interrupt for use in run, wait and stop
Loop-control Pierce oscillator (XOSC)
Internal clock source (ICS)
Watchdog computer operating properly (COP) reset
Low-voltage detection with reset or interrupt - selectable trip points
Illegal opcode detection with reset
Illegal address detection with reset
Flash BLOCK protect
8-bit Modulo counter with 8-bit prescaler and overflow interrupt
Two 2-channel Timer PWM modules (TPM1, TPM2)
8 Interrupt pins with selectable polarity
Hysteresis and configurable pull up device on all input pins
Configurable slew rate and drive strength on all output pins
Single-wire background debug interface
Breakpoint capability to allow single breakpoint setting during in-circuit debugging
In-circuit emulation (ICE) debug module
应用
工业
产品信息
产品范围: S08 Family S08SH Series Microcontrollers CPU速度: 40MHz 程序内存大小: 4KB 存储器容量, RAM: 256Byte 针脚数: 16引脚 MCU 封装类型: TSSOP 输入/输出数: 13输入 嵌入式接口类型: I2C, SCI, SPI 电源电压最小值: 2.7V 电源电压最大值: 5.5V MCU系列: S08 MCU系列: S08SH 汽车质量标准: - MSL: MSL 3 - 168小时